Standard of laser path adjustment
2016-12-30

Standard of laser path adjustment

During operation, in case of no laser or the laser out of its path, please refer to below methods to adjust laser path.

Step 1: make sure laser from laser tube reach the center of 1# reflector; 

 

Step 2: stick double glue paper on reflector 2# (or some other materials which can be marked by laser), move the rail to the place nearest to laser tube. Press “Laser” (with proper laser power) and mark a hole (Special Notice: Before adjust the laser, please first test the general position of the laser with a paper board to avoid personal injuries).  

 

 

Step 3: move the rail gradually to the place furthest from laser tube, press “Laser” and mark a hole;   

 

Step 4: if the two mark holes don’t superpose, adjust 1# and make these two holes overlap;  

 

Step 5: repeat operation from Step 2 to Step 4, until the two holes completely superpose. 

 

Step 6: stick double glue paper on reflector 3# (or some other materials which can be marked by laser), move the trolley to the position nearest to 2#, press “Laser” (with proper laser power) and mark a hole.  

 

Step 7: move the rail gradually to the place furthest from 2#, press “Laser” and mark a hole(Notice: Before adjust the laser, please first test the general position of the laser with a paper board to avoid personal injuries). 

 

Step 8: if the two mark holes don’t superpose, adjust 2# and make these two holes overlap; 

 

Step 9: repeat operation from Step 6 to Step 8, until the two holes completely superpose. 

 

Step 10: stick double glue paper on light entrance hole in front of 3#, press “Laser” and mark a hole. 

 

Step 11: if the laser doesn’t reach the center of the light entrance hole, as shown in below Fig:  

 

 

In this case, the laser hole is in upper right. 

 

Rising or descending laser tube. 

 

Forth or back laser tube. In this case, you must lower laser tube, then adjust from the Step 1.  

 

Notice: the operator should be professionally trained, or should ask help from professional persons. Make sure the safety during operation and avoid personal injuries caused by laser emission.